$400.00 AUD $360.00 AUD
EXPRESS SHIPPING OF BATTERIES NOT PERMITTED.
SHIPPING WITHIN AUSTRALIA ONLY.
480CCA, 12.8V, 16Ah (PB Eq), 65mm thin, lithium ion motorcycle battery - perfect for custom builds.
Around 22% thinner than an Antigravity 480CCA battery!!!
Takes up around 25% less space than an Antigravity 480CCA battery!!!
26% lighter than an Antigravity 480CCA battery!!!
They measure a tiny 145 x 95 x 65mm (+/- 4mm tolerance)*.
Weight is just 1030 grams!!!
Mountable in any orientation, they can be easily hidden under seat's, etc.
Unlike other lithium ion motorcycle batteries, these have a built in Power Circuit Management (PCM) system which protects the battery from over-charging, over-discharging, over-heating, and voltage overload, ensuring the safety of both battery and bike!
Without a PCM, a lithium ion battery can be permanently destroyed when using a faulty regulator/rectifier as an example. This battery on the other hand will automatically disconnect itself from the electrical system, preventing any damage from occurring. Recharging the battery re-sets it for use again. Note: if this occurs, it is advised to have your electrical system faults rectified, as to continue to operate the battery in this manner will eventually cause permanent damage.
The cells and PCM are first wrapped in 4-5mm EVA padding, then wrapped in epoxy board and finally PVC shrink-wrapped.
Cable length is 75mm (positive cable) and 150mm (negative cable).
Being a fully-fledged motorcycle battery, they are a direct replacement for your original battery. Provides a significant space and weight saving.
No need to give up your electric start! Enough current to start street bikes up to approximately 1700cc and race bikes up to 2200cc (please check your owners/workshop manual or other sources for the minimum recommended battery CCA rating for your bike).
New Technology, NO-LEAD and NO-ACID Battery.
Longer life than lead/acid. These batteries are not affected by vibration or heat as are lead/acid batteries.
No trickle charging needed. They can hold a charge up to a year! Lithium does not suffer from a "natural discharge" that lead does so it holds it's charge without the need of a trickle charger.
*Due to the way the battery is wrapped there can be a variation of +/- 2mm in the final dimensions to what we have specified here. We advise that you do not start making cradles, etc. for this battery until you have received your order and taken your own measurements.
DO NOT USE A BATTERY WHICH IS BELOW THE MINIMUM REQUIRED CCA AS ADVISED BY THE BIKE MANUFACTURER. THE BATTERY MAY BE DAMAGED AS A RESULT.
We are not permitted to ship batteries outside of Australia. If you place an order for a battery to be shipped outside of Australia, we will have to cancel the order. Please note a $3 cancellation fee will be charged.
PRE-ORDER ONLY. DISPATCHES IN 1 TO 2 WEEKS. The Handle Bar Clip Kit allows mounting the motoscope mini or motosign mini directly to the handlebar. Kit includes: Two clamps with stainless steel mounting screws.
$27.00 AUD $23.50 AUD
The Teardrop Key, used as 'user key', is a replacement or additional key for the m.lock RFID ignition lock.
$155.00 AUD $145.00 AUD
The PLUS is where it's at! The m.relay+ purposefully combines a load independent digital flasher relay and electronic push-button controls. Depending on how long the respective turn signal push-button is activated, 4 different operating modes are available: Change of lane: Short tap on push-button -...