Switch Block, Low Profile, Black (button X2)

Mini switch block in black with a low-profile, curved fascia.

Comes with 2 x push-button switches as shown in the first image (other images depict the toggle and push version).

Designed to sit flush on 7/8" handlebars, however they will fit 1" bars leaving just a slight gap as shown in last two images.

Designed by us here at MMCC, we've had the wires soldered on for you as we know how easy it is to destroy the switches by putting slightly too much heat in during soldering.

Wiring length: 85cm.

Suitable for horn, starter, kill switch (may require relay), etc. Also works with motogadget mo.unit.

This listing is for 1 switch block with 2 pre-wired switches.

Machined from billet aluminium. Great for that uncluttered look. Switch block body measures 41mm long x 18mm wide. Eliminate the need for your stock switch blocks. These mini switches have a contoured base designed to sit flush on 7/8" handlebars.

Depending on your build, you may be able to get away with just 1 switch block. Others may require 2 - one for each side.

Easy to install. Requires drilling 2 x 9mm holes. A 3.3mm hole needs to be drilled between the 9mm holes and tapped with an M4 tap to create threads for the supplied M4 screw which fastens the switch to the bar (nut shown in images is there to keep mounting screw in place during shipping and can be discarded). All the associated wiring can be routed through the handlebar to an exit point of your choosing.

The button is a "push-on" momentary type (active only whilst pressing).

The push-button switch can handle around 4 amps. If you want to run higher loads than this, you will need to run them via relays.