motogadget mo.button

Use this in combination with the mo.unit to reduce cable clutter and simplify your wiring harness.

Installed into the handlebar tube (or other suitable location) this tiny cylinder connects to all your handlebar switches and buttons, relaying all their signals down one, thin wire from the handlebars to the mo.unit!

Using state-of-the-art bus technology, the mo.button digitally processes signals and transmits them to the mo.unit blue or mo.unit basic over a thin cable. The electrical load is then switched inside the mo.unit. All control wires are contained within the handlebar. This saves space, weight, labour and time. A 'must have' for custom bikes with clean-look handlebars.

Normally, the operating current (e.g. headlight or turn signals) is transmitted directly via the wiring of the handlebar switches. Due to the high currents, cables with large cross-sections have to be routed from the fuse box to the switch and back to the electrical load. The result: big cable bundles. Far from ideal for a custom bike with restricted space or when trying to conceal your wiring harness.

By using the mo.unit alone without the mo.button, just one thin cable for each switch or button-controlled feature needs to be routed to the mo.unit. These cables only carry minute control currents. All high loads and currents are switched directly at the mo.unit and transmitted directly to the electrical load. This already leads to a significant reduction and simplification of the wiring harness.

You can reduce this cabling even further with the addition of a mo.button. All switches/buttons on the handlebar are connected at the shortest distance possible and concealed inside the handlebar. Consequently, you will have to route only ONE thin cable from the mo.button to the mo.unit. 

The mo.button is completely moulded in, making it water-proof and resistant to vibrations.

Equipped with connections for:
- indicator, left side
- indicator, right side
- headlight (low beam and high beam)
- electric starter
- horn
- brake light

Diameter: 12 mm
Length: 25 mm
Cable length: approx. 60 cm
Connecting cable to mo.unit: approx. 200 cm
Weight: approx. 30 g

Pin It

Frequently purchased together: